____________________________________________________________________________________
| Home / Car Engines / BMW Engines / BMW M52B28TU |
BMW M52B28TU Troubleshooting
| Engine will not start or starts up hard |
Empty gas tank - Fill it up.
Improper fuel grade - Change fuel.
Dirt and debris in fuel system - Remove debris and dirt.
Faulty spark plug wire connection - Check spark plug wiring connection, repair or change.
Faulty spark plug - Spark plug need to be replaced.
Ignition system is defective - Check ignition and replace faulty components.
Dirty fuel filter - Replace fuel filter.
Clogged fuel lines - Clean fuel system lines.
Fuel pump is clogged or faulty - Check fuel pump and replace if necessary.
Fuel injectors are defective or dirty - Test fuel injectors and change if necessary.
Low compression - Check and replace worn parts.
| Unstable engine running |
Ignition system problems - Inspect ignition system and change failed components.
Air filter element is plugged - Clean or replace air filter.
Defective spark plug - Change spark plug.
Clogged or damaged fuel pump - Service or change fuel pump.
Valve clearance is wrong - Adjust valve clearance.
Ignition timing is incorrect - Ignition timing needs to be set properly.
Wrong adjustment of low idle speed - Adjust idle speed.
| Engine starts and stops suddenly |
Defective spark plug - Spark plug need to be replaced.
Fuel injectors are damaged or dirty - Clean or change fuel injectors.
Ignition coil is faulty - Change ignition coil as required.
Broken or loose valve springs - Install new valve springs.
Stuck valves - Valves must be cleaned.
| Engine keeps overheating |
Engine oil level is insufficient - Add oil to the engine crankcase.
Excessive engine load - Load reducing is recommended.
Dirty fuel injectors - Need to clean fuel injectors.
Ignition timing is improper - Set the ignition timing properly.
Incorrect valve setting - Adjust valves correctly.
Clogged radiator core or leaking radiator cap - Clean radiator or replace cap.
Engine coolant is insufficient - Fill the cooling system and check components for leaks or other faults.
Thermostat is faulty - Thermostat need to be replaced.
Damaged water pump - Water pump need to be replaced.
| Engine noises or knocks |
Stale gasoline - Change gasoline.
Engine is overloaded - Load reducing is recommended.
Low engine oil level - Need to add engine oil.
Low idle speed setting is incorrect - Adjust the low idle speed.
Fuel pump is damaged or dirty - Inspect fuel pump and change as required.
Crankshaft or main bearings are worn out - Replace crankshaft or bearings.
Valve clearance is incorrect - Check and adjust.
Cylinder bore or piston rings are damaged - Replace faulty parts.
| Low engine power |
Fuel injectors are clogged or faulty - Clean or change fuel injectors.
Air filter is dirty - Service or change air filter.
Clogged or damaged fuel pump - Inspect fuel pump and change as required.
Ignition failure - Inspect ignition system and change failed components.
Cylinder head gasket is blown - Install new cylinder head gasket.
Burned or stuck valves - Clean or change valves.
Damaged cylinder block components - Replace defective components.
Plugged oil filter - Clean or change oil filter.
| Engine uses too much fuel |
Plugged air filter - Clean or change air filter.
Clogged or defective fuel injectors - Test fuel injectors and replace if necessary.
Loose or defective spark plug - Spark plug need to be replaced or tightened.
Wrong ignition timing - Ignition timing needs to be set properly.
Valves are worn, burned or stuck - Service or change valves.
Worn sleeve, rings, or piston - Replace defective components as required.
Valve clearance is incorrect - Check and adjust.
Weak cylinder compression - Inspect cylinder block and change worn parts.
| Engine using too much oil |
Seals or gaskets are defective - Replace to repair leaks.
Valve guides or stems are damaged - Change the valves.
Stuck or defective piston rings - Change piston rings.
Damaged piston or cylinder liner - Check piston and liner, change as required.
| Engine backfires |
Clogged fuel injectors - Need to clean fuel injectors.
Fuel lines clogging - Clean fuel lines.
Ignition timing is improper - Ignition timing needs to be set properly.
Wrong valve setting - Set the valves correctly.
Plugged air filter - Change or service air filter.
____________________________________________________________________________________
____________________________________________________________________________________