GASOLINE AND DIESEL ENGINES SPECIFICATIONS

____________________________________________________________________________________

Home / Car Engines / BMW Engines / BMW M50B24TU

BMW M50B24TU Troubleshooting

Engine will not start or starts up hard

No gasoline in tank - Fill fuel up.
Wrong fuel grade - Use quality gasoline.
Clogged fuel system - Remove clogging.
Spark plug wiring connection is defective - Check the spark plug wire connection, repair or replace.
Faulty spark plug - Spark plug need to be replaced.
Ignition failure - Check ignition and replace faulty components.
Fuel filter is dirty - Replace fuel filter.
Restricted fuel lines - Service fuel lines.
Dirty or damaged fuel pump - Clean or replace fuel pump.
Clogged or defective fuel injectors - Service or change fuel injectors.
Low engine compression - Inspect cylinder block and change defective components.

Engine runs roughly

Ignition system malfunction - Check ignition system and replace faulty parts.
Air filter is dirty - Service or replace air filter.
Defective spark plug - Install new spark plug.
Clogged or defective fuel pump - Check fuel pump and replace if necessary.
Improper valve clearance - Need to adjust valve clearance.
Ignition timing is incorrect - Set the ignition timing properly.
Too low idle RPM - Correct the settings.

Engine starts but stalls suddenly

Faulty spark plug - Install new spark plug.
Dirty or damaged fuel injectors - Service or change fuel injectors.
Ignition coil is defective - Ignition coil must be replaced.
Bad or broken valve springs - Replace valve springs.
Stuck valves - Service the valves.

Engine overheated

Engine oil insufficient - Fill the crankcase with engine oil.
Engine overloaded - Load reducing is recommended.
Fuel injectors are dirty - Need to clean fuel injectors.
Ignition timing is wrong - Set the ignition timing properly.
Incorrect valve setting - Set the valves correctly.
Damaged radiator cap or dirty radiator core - Clean radiator or replace cap.
Lack of coolant in cooling system - Refill to the correct level and inspect system for leaks.
Damaged thermostat - Replace thermostat.
Defective water pump - Replace water pump.

Engine knocking sound or abnormal noise

Low octane gasoline - Change gasoline.
Engine is under excessive load - Reduce the load.
Engine oil insufficient - Fill the crankcase with engine oil.
Too low idle RPM - Correct the settings.
Fuel pump is dirty or defective - Service or change fuel pump.
Main bearings or crankshaft wear - Replace crankshaft or bearings.
Incorrect valve clearance - Adjust valve clearance.
Cylinder bore or piston rings are worn - Change defective parts.

Lack of engine power

Fuel injectors are defective or dirty - Check fuel injectors and replace if necessary.
Air filter element is plugged - Change or service air filter.
Fuel pump is dirty or defective - Test fuel pump and replace if necessary.
Ignition system problems - Inspect ignition system and change faulty parts.
Damaged cylinder-head gasket - Replace the gasket as required.
Burned or stuck valves - Change or service valves.
Cylinder block parts are worn out - Change defective components.
Dirty oil filter element - Replace or clean oil filter.

Excessive fuel consumption

Plugged air filter - Replace or clean air filter.
Dirty or faulty fuel injectors - Test fuel injectors and change if necessary.
Spark plug is defective or loose - Tighten or change the spark plug.
Ignition timing is incorrect - Adjust ignition timing correctly.
Valves are stuck, burned, or worn - Clean or replace valves.
Worn piston, rings, or sleeve - Replace defective parts.
Valve clearance is not correct - Adjust valve clearance.
Poor compression - Inspect and replace wear parts.

Engine using too much oil

Damaged seals or gaskets - Worn parts need to be replaced.
Valve guides and stems are worn - Valves need to be changed.
Piston rings are stuck or worn - Piston rings replacement required.
Cylinder liner or piston is scored - Check liner and piston, replace as required.

Engine backfires

Fuel injectors are clogged - Service or replace fuel injectors.
Restricted fuel lines - Clean fuel lines.
Wrong ignition timing - Adjust ignition timing as required.
Improper valve setting - Set the valves properly.
Air filter is blocked - Service or replace air filter.

____________________________________________________________________________________

____________________________________________________________________________________